Description
The Netvio IP-SW-24P-10 is a dedicated plug ‘n’ play AVoIP Switch designed for use with Netvio and other AV over IP solutions. It comes preconfigured for multicast AVoIP solutions, requiring zero configuration for systems with up to 21 encoders and/or decoders.
All ports support POE with a total 450W PoE budget, which is large enough to power devices connected to all ports simultaneously.
There is an additional Gigabit copper and dual SFP fibre module ports for local area connection, enabling the distribution of JP4 series preview streams without complicated VLAN configuration.
The Netvio IP-SW-24P-10 is designed and suitable for systems with 21 or less AVoIP end points only. Multiple IP-SW-24P-10 switches cannot be used in the same system unless they are completely isolated systems. It is only designed to connect to AVoIP encoders and decoders.
Please Note: Due to its configuration, it is not recommended that other AV or IT equipment is connected to this switch.
This switch’s power input supports input voltages of 100 to 240VAC, 50/60Hz.
The power LED lights up when the switch is connected to a power source and the rear switch is powered on. The link indicator light indicates the network connection through the corresponding port. Flicker indicates that the switch is sending or receiving data PoE indicator: The ‘On’ indicates that a device is connected to the corresponding port and drawing power and the ‘Off’ indicates that the port is not powered or no device is found.
For grounding, please use specialised ground lead connected to the ground.
- Zero configuration
- Plug ‘n’ play for Netvio IP video and control solutions
- 24 Gigabit ports with PoE
- Connectivity for Netvio IP-JP4-CL-10 and up to 21 TX, RX end points
- Large 450W PoE budget to power every connected device
- Additional Gigabit copper and SFP fibre module ports for local area connection
| Network Interfaces | 24 x 10/100/1000Mbps RJ45 Ethernet ports 2 x 1Gbps SFP Ports |
| LED Indicators | Power, Link, PoE |
| Performance | |
| Switching Capacity | 52Gbps |
| Jumbo Frame Size | 16KByte |
| Forwarding Capacity | 38.7Mpps |
| ACL Table | 512 |
| Forwarding Mode | Store and forward |
| VLANs | 2, Packet Buffer Memory 4.1Mbit |
| RAM for CPU | 1Gbit |
| Flash Memory | 128Mbit |
| MAC Address Table | 8K |
| Power Method | 100 to 240VAC 50/60HZ |
| Power Consumption | 30W |
| Power Over Ethernet | |
| PoE Ports | 24 |
| PoE Standard | IEEE802.3af IEEE802.3at |
| PoE Power Budget | 430W |
| Max. PoE Wattage Per Port | 30W |
| PoE Voltage | 52V |
| PoE Pin Assignment | V- (RJ45 pin 1,2), V+ (RJ45 pin 3,6) |
| Casing | Metal |
| Temperature | Operating: 0°C / 32°F to 40°C / 104°F Storage: -10°C / 14°F to 75°C / 167°F Operating Humidity: 5% to 95% non condensing |
| Dimensions | Height: 44mm / 1.73″ Width: 440mm / 17.32″ Depth: 200mm / 7.87″ |
| Installation | Rack mount or desktop |
| Included | Netvio IP-SW-24P-10 UK and EU mains cables Rack mount and screws Four switch rubber feet |
Videos:
NET-IP-SW-24P-10.pdf